Epoxy Glue Sandstone Porcelain Floor Tile Adhesive For Natural Stone PB-01 manufacturer from China Guangzhou Pinbang Building lndustrial co.,LTD

Epoxy Glue Sandstone Porcelain Floor Tile Adhesive For Natural Stone

Place of Origin:

Zhejiang, China (Mainland)


	Add to My Favorites
HiSupplier Escrow	Share \|

Product Detail

Model No.: PB-01

Epoxy Glue Sandstone Porcelain Floor Tile Adhesive For Natural Stone

<span

Epoxy Glue Sandstone Porcelain Floor Tile Adhesive For Natural Stone

The product is a new type strong adhesive, applied to indoor and outdoor wall paste of large-scale ceramic tile, grassing stone, natural stone material, modifies epoxy glue with features of strong adhesive strength, low stress, low dilatability, no bubble, quick set, proper viscosity and easy operate, resistant of grind, aging, cold-hot exchange.

Features:

1, A new type strong stone adhesive, applied to all kinds of ceramic tile and stone material.

2, No need to wet the brick wall, effectively improve the efficiency.

3, Strong bond ability, material-reducing, much safer and firmer than the traditional cement adhesive, also can reduce the construct rubbish and the weight of the wall.

4, Good anti-infiltration and anti-aging function.

5, Can be directly used for floating rough surface, or smooth cement floor.

Surface Treatment:

The substrate surface should be firm, dry and clean, no grease, no wax, or other loose materials.

Operation Process:

1, The ratio:PB-01: water=3.3: 1 (20kg/bag, about 6kg water).

Stirring them into paste, using an electric mixer to make uniform paste, put it aside for a few minutes and then a little stirring to gain the better effect.

2, Using tooth scraper to scrap the adhesive onto the surface evenly, control within 1, then push the ceramic tile above it.

3, For the tile or stone material with deep ditch, not only scrape the surface, but also the backside of the tile or stone.

4, Leave 1.5mm joint space between two tiles, suggesting PB-MC color anti-moldy gap filler.

Cautions:

1, Make sure the smooth and vertical rate of the surface before operation.

2, For the ceramic tile or stone material with low water-absorption, please use PB-03 additive or PB-05 adhesive directly (specific refer the PB-03 and PB-05 product introduction).

3, Can not be walked on or filled crack unless finished after 24h.

4, Operating under 5~40.

5, Can be used with brick gap adhesive.

6, Never mix the dried slurry with water for second use.

7, Clean the surface by slightly wet sponge or cloth before it dried.

Technical Reference:

Coverage area(amount)	Technical reference
coverage area differs according to the circumstance	1, adjust time: about 15min (adjust time: the effective time for the dislocation to adjust)
1, using 3×3mm tooth scraper about 1.7kg/	2, cool time: about 10min (cool time: the longest cool time that the adhesive can last )
2, using 6×6mm tooth scraper about 3.0kg/	3, initial dry time: 48h(dry solid water resistance)
2, using 6×6mm tooth scraper about 3.0kg/	4, dry time: 24h (according to the weather)
3, using 10×10mm tooth scraper about 4.5kg/	5, water resistance: excellent
3, using 10×10mm tooth scraper about 4.5kg/	6, anti-weak acid, anti-strong alkali and oil resistance when dried
4, the smoother the surface, the less amount	7,non-toxic, prevent fire
4, the smoother the surface, the less amount	8, cut degree: 1.2MPa (14days later), 1.5MPa(28days later)