Color Epoxy Bathroom Tile Grout For Ceramic Tile Adhesive

Technical Features:

Pinbang color epoxy grout is one kind of double-component epoxy resin product, contains silica sand and special additives. Excellent acid resistance and clean power. It has the following characteristics:

1, Excellent mechanical strength and chemical resistance, more durable.

2, The surface is smooth after finished caulking, low water-absorption and easy to clean.

3, Easy to use and the surface can be quickly repaired.

4, Being high load resistant after the grout dried.

5, No shrinkage and no cracking.

6, Uniform color, uvioresistant and atmospheric-corrosion-resistant.

7, Excellent binding power.

Using Suggestion:

1, Thin thickness. Pinbang color epoxy grout can also caulk the seams less than 3mm of glass mosaic.

2, When caulking the brick corners which are too wet or polluted by dirt and grease, Pinbang color epoxy grout does not guarantee to paste intactly.

3, Unglazed quarry brick should be used the same color with grout, other kinds of color only can be used for enamel brick.

4, Pinbang color epoxy grout cannot be used on ceramic tile, for it hard to clean.

5, Caulking the vitrified bricks that have a large color difference with grout, must carry on a preliminary test before operation (such as caulking the white brick with a black color).

6, Before caulking the stone or smooth vitrified brick, carries on a preliminary test first.

7, Do not add water or solvent in order to increase the liquidity of the grout.

8, Should be used in 12 ~30 temperature range .

9, Mix the product in right mixing ratio in strict accordance with the requirements.Incorrect mixing ratio may affect the hardening of the product.

Operation Steps:

Used as acidoresistant grout:

1,Joint preparation:

1)The gap must be clean, no dust, the depth of the seam should be at least two-thirds of the thickness of the ceramic tile. Do the clearance before the mortar dried.

2)Make sure the tile adhesive or mortar have hardened and volatilized most of the moisture before grouting.

3) Moisture on the brick surface does not affect the grouting. The brick seam should not be wet when grouting.

2,Mixing:

Pouring the hardener B component into the container which contains A component, stirring them into a uniform state. Use a slow stirrer to avoid overheating and reduce the working hours of the product. The grout should be used up within 45 minutes after stirred.

3, Jointing:

Use a proper-size Pinbang scraper to fill the brick seam with the grout. Blow away the needless grout with a same-tooth-surfacethe scraper.

4, Surface dressing:

1) After jointed, clear the grout on the ground and the wall immediately before the grout dried out.

2) Wet the surface with Scotch-Brite fully, don't scour the brick seam. The clean cushions should be fully wetted when cleaning the surface.Wipe away the needless grout with a wet-porous-hard sponge, which should be replaced with another if it gets filled with resin.

3) Extremely important, when finished surface dressing, it is not allowed that Mebong Color Epoxy Grout remain on the surface of the ceramic tile for it difficult to clean.So it is necessary to water the sponge constantly.

Store Method:

Store in cool and dry place, unopened product can be saved for one year.

Packing:

20kg/bag